Rockwell Automation VSM500 Integrated Drive/Motor DeviceNet Option Board - Manual (Page 11)

Getting Started 1-1
C
HAPTER
1
Getting Started
This chapter provides an overview of the VSM500 DeviceNet option board and the
steps that you need to start using it.
1.1 Components
The following figure illustrates some of the DeviceNet option board components.
Figure 1.1 – DeviceNet Option Board Components
# Part Description
1 Access
to Unit
Switches Rotary switches and DIP switches on the VSM500 unit can be
accessed through the holes and underneath the DeviceNet
option board.
2 Unit Cable A ribbon cable that connects to the VSM500 unit.
3 Ground A ground for the DeviceNet option board. When the lock washer
and a screw from the installation kit are secured in the upper
right corner, the option board is grounded.
4 Label Labels identifying the ASA serial number, manufacture date,
manufacturer, catalog number, and firmware release.
5 DIP
Switches Switches that you set to configure the node address and data
rate.
6 DeviceNet
Connector A DeviceNet connector that will accept an open-style linear
plug.
Installation
Kit
(not shown) An installation kit consisting of one grounding wrist strap, one
10-pin open-style linear plug for DeviceNet, screws, and a lock
washer. These items are used to secure the DeviceNet option
board to the VSM500 unit and connect it to the network.
Top View
①
②
⑥
③
④
⑤