Rockwell Automation VSM500 Integrated Drive/Motor DeviceNet Option Board - Manual (Page 15)

Installing the DeviceNet Option Board 2-1
C
HAPTER
2
Installing the DeviceNet Option Board
This chapter provides instructions for installing and wiring the DeviceNet option board
on the VSM500 Integrated Drive/Motor.
Read this chapter and referenced information completely before you attempt to install
or configure the DeviceNet option board. Before you apply power, review the attention
statements on the inside front cover of this manual.
2.1 Preparing for the Installation
Before installing the drive, do the following:
• Read and understand the DeviceNet Cable System Planning and Installation
Manual. See the Preface in this manual for how to obtain this manual.
• Read and understand the VSM500 Integrated Drive/Motor User Manual.
• Verify that you have the required equipment. Refer to Chapter 1.
2.2 Complying with EMC Directive 89/336/EEC
This product complies with Electromagnetic Compatibility (EMC) Directive
89/336/EEC when conforming with the following installation requirements:
• The essential requirements for a conforming installation for the VSM500 Integrated
Drive/Motor are employed as specified in the
VSM500 Integrated Drive/Motor User
Manual.
2.3 Complying with Low Voltage Directive 73/23/EEC
This product complies with Low Voltage Directive 73/23/EEC when conforming with
the following installation requirements:
• The essential requirements for a conforming installation for the VSM500 Integrated
Drive/Motor are employed as specified in the VSM500 Integrated Drive/Motor User
Manual.
• Review the Safety Precautions on the inside front cover of this manual and the
Attention statements throughout this manual prior to installation of the option.