Rockwell Automation VSM500 Integrated Drive/Motor DeviceNet Option Board - Manual (Page 38)

4-6 VSM500 DeviceNet Option Board
4.2.1 Mapping the Input I/O
Step 1. In the Scan List Editor dialog box (see figure 4.9), click Datatable Map under
Scan List Tools. The Datatable Map dialog box appears.
Step 2. Next to Display Mode, select Data Entry. A dot appears in the circle.
Step 3. Next to Data Map, select Input to map the input data.
Step 4. In the Map Data To box, select where the data is to be placed.
Step 5. In the Map Data From box, select from where the data is received.
Step 6. In the I:1. box, type the word where the data will be mapped. In the example,
it is mapped to word 1 (second word).
Step 7. In the Bit box, type the bit at which the data starts.
Step 8. In the No. Bits box, type the number of bits that your data requires.
Step 9. Click Apply Segment. A new datatable map appears in the dialog box.
Figure 4.10 – Datatable Map Dialog Box
Figure 4.11 – Input Datatable Map
ф
н
ч
ы
ш
щ
о
ь