Rockwell Automation VSM500 Integrated Drive/Motor DeviceNet Option Board - Manual (Page 22)

3-2 VSM500 DeviceNet Option Board
Step 3. Under Available DeviceNet Drivers, select a DeviceNet driver, and then click
OK. The Driver Configuration dialog box appears.
Step 4. Select the appropriate settings for the following:
Step 5. Click OK to go online. The online icon is displayed under Comm in the lower
right corner of the main window.
Figure 3.1 – DeviceNet Driver Selection Dialog Box
Figure 3.2 – Driver Configuration Dialog Box
Box Description
Serial Port
Setup Select the communications port on your computer to which the DeviceNet
adapter is connected.
Baud Rate Select the baud rate that is used by your computer communications port.
Node
Address Type a unique node address for the computer on the DeviceNet network.
Usually, computers use the node address 62. Do not use 63 because this is the
factory-default setting for new devices on the network.
Data Rate Select the data rate that devices on the DeviceNet network are using.
Figure 3.3 – DeviceNet Manager in Online Mode Icon