Metrohm 915 KF Ti-Touch - Manual (Page 249)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
27 Manual control
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 235
27.2 Measuring
Manual control ▶ Measure
Manual measurements can be carried out with the function [Measure].
Proceed as follows:
1 Select a sensor
￭ Select the desired sensor from the sensor list.
All of the sensors available in the sensor list are displayed. Sensors
are defined under System
▶ Sensors.
￭ Select the measuring input at which the sensor is connected.
2 Select a measuring mode
￭ Select the desired measuring mode.
Only those measuring modes are displayed which are advisable
for the selected sensor.
3 Enter a measuring temperature
￭ Enter the measuring temperature if no temperature sensor is con-
nected. If a temperature sensor is connected, then the tempera-
ture will be measured automatically.
4 Start the measurement
￭ Tap on [Start].
The measured value display is opened: