Metrohm 915 KF Ti-Touch - Manual (Page 97)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
11 Device manager
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 83
￭ Properties of the peripheral devices on the MSB connector (see Chap-
ter 11.4.3, page 85)
11.4.1 Properties – Measuring input
List of devices: Control device ▶ Edit ▶ Measuring input 1 ▶ Proper-
ties
In this dialog, you define the type of temperature sensor you have con-
nected to the selected measuring input.
ADC type
Type of analog-digital converter.
Serial number
Serial number of the measuring interface.
Thick film type
Type of the thick film.
Temperature sensor
Type
The instrument supports the use of two different temperature measure-
ment techniques:
￭ NTC (Negative Temperature Coefficient)
￭ Pt1000 (Platinum resistance)
Select here the type that has been connected to the instrument. If an NTC
sensor is used, then it is also necessary to enter two sensor characteristics.
These characteristics are listed in the specifications of the sensor.
Selection Pt1000 | NTC
Default value Pt1000