Metrohm 915 KF Ti-Touch - Manual (Page 38)

6.1 Switching the instrument on and off
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
24 ￭￭￭￭￭￭￭￭
915 KF Ti-Touch
6 Operation
6.1 Switching the instrument on and off
Switching on the instrument
CAUTION
Peripheral devices (e.g. printers) must be switched on before you switch
on the 915 KF Ti-Touch.
Proceed as follows:
1 ￭ Press the mains switch on the left-hand side of the rear panel of
the 915 KF Ti-Touch.
The 915 KF Ti-Touch is initialized. A system test is performed. This
process takes some time.
￭ If a buret unit is attached, then a request appears to carry out the
Prepare function:
All tubings and the cylinder are rinsed with the Prepare function.
The preparing of the buret unit is described in chapter 27.3.3,
page 244.
￭ Confirm the message with [OK].
The main dialog is displayed: