Metrohm 915 KF Ti-Touch - Manual (Page 39)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Operation
915 KF Ti-Touch
￭￭￭￭￭￭￭￭ 25
Switching off the instrument
CAUTION
The 915 KF Ti-Touch must be switched off by pressing the mains switch
on the rear of the instrument before the electricity supply is interrupted.
If this is not done, then there is a danger of data loss.
Proceed as follows:
1 ￭ Press the mains switch on the left-hand side of the rear panel of
the 915 KF Ti-Touch.
The current data is saved and the system is shut down. This process
takes just a short time. At the same time, all other devices connected
to the 915 KF Ti-Touch via a USB cable are also being switched off.