Dell PowerVault MD3000 - Manual (Page 124)

124
Script Commands
Parameters
Parameter Description
physicalDiskCount Number of unassigned physical disks to
use in the disk group.
NOTE:
The physicalDiskCount parameter
enables you to choose the number of
physical disks to use in the disk group. You
do not need to specify the physical disks by
enclosure ID and slot ID. The RAID
controller modules choose the specific
physical disks to use for the disk group.
raidLevel RAID level of the disk group that contains
the virtual disk. Valid values are 0, 1, or 5.
userLabel Name to give to the new virtual disk. You
must put quotation marks (" ") around
the new virtual disk name.
physicalDiskType Specifies the type of physical disk to use
in the virtual disk. You cannot mix
physical disk types in the virtual disk.
Valid physical disk types are SAS or SATA.
capacity The size of the virtual disk that you are
adding to the storage array. Size is defined
in units of bytes, kilobytes, megabytes, or
gigabytes.
NOTE:
A space must be added between
the last digit and the size (MB, GB, or KB)
for values greater than 9.