Start physical disk blink, Start physical disk initialize – Dell PowerVault MD3000 User Manual
Page 216
216
Script Commands
NOTE:
This operation ends the iSCSI connections for the portal and brings down
the portal temporarily.
Start Physical Disk Blink
This command identifies a physical disk by turning on the indicator LED on
the physical disk. (Use the stop physicalDisk blink command to turn off the
indicator LED on the physical disk.)
Syntax
start physicalDisk [
enclosureID,slotID
] blink
Parameters
Start Physical Disk Initialize
This command starts physical disk initialization.
NOTICE:
As soon as you enter this command, all user data is destroyed.
Syntax
start physicalDisk [
enclosureID,slotID
] initialize
Parameters
Parameter
Description
physicalDisk
Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.
Parameter
Description
physicalDisk
Identifies the enclosure and slot where the physical disk resides.
Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID value and slot
ID value.