Dell PowerVault MD3000 - Manual (Page 174)

174
Script Commands
Parameters
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
This command changes the host type for an HBA host port. You can also
change an HBA host port label with this command.
Syntax
set hostPort [ portLabel ] host= “hostName”
userLabel= “newPortLabel”
Parameters
Parameter Description
hostGroup Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
userLabel New name for the host group. You must put
quotation marks (" ") around the host group
name.
Parameter Description
hostPort The name of the HBA host port for which you want to change the
host type, or for which you want to create a new name. Enclose the
HBA host port name in square brackets ([ ]). If the HBA host port
label has special characters, enclose the HBA host port label in
double quotation marks (“ ”).
host The name of the host to which the HBA host port is connected.
Enclose the host name in double quotation marks (“ ”).
userLabel The new name that you want to give to the HBA host port. Enclose
the new name of the HBA host port in double quotation marks
(“ ”).