Start enclosure blink, Start iscsi dhcp refresh – Dell PowerVault MD3000 User Manual
Page 215
Script Commands
215
Parameters
Start Enclosure Blink
This command identifies an enclosure by turning on the indicator LED. (Use
the stop enclosure blink command to turn off the indicator LED for the
enclosure.)
Syntax
start enclosure [
enclosureID
] blink
Parameters
Start iSCSI DHCP Refresh
This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP,
the procedure returns an error.
Syntax
start storageArray [
iscsi-host-port
] dhcpRefresh
Parameter
Parameter
Description
diskGroup
Number of the disk group to defragment. You
must put brackets ([ ]) around the disk group
number.
Parameter
Description
enclosure
Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Parameter
Description
iscsi-host-port
The identifier of the port on the storage array on which you want to
refresh the DHCP parameters. Enclose the iSCSI host port name in
square brackets
([ ]).