Dell PowerVault MD3000 - Manual (Page 164)

164
Script Commands
Parameters
Save Storage Array iSCSI Statistics
This command saves the storage array iSCSI performance statistics to a file.
The following statistics are saved to the file:
• Statistics related to the physical Ethernet port
• Statistics related to the TCP protocol
• Statistics related to the IP protocol
Syntax
save storageArray iscsiStatistics [raw | baseline]
file= “filename”
Parameters
Parameter Description
allEvents | criticalEvents Specifies whether to save all events (allEvents) or only
the critical events (criticalEvents).
file Name of the file to which to save the events. You must
put quotation marks (" ") around the file name.
count Specifies the number of events or critical events to save
to a file. If you do not enter a value for the count, all
events or critical events are saved to the file. If you enter
a value for the count, only that number of events or
critical events (starting with the last event entered) are
saved to the file. Use integer values.
Parameter Description
raw This parameter defines that the statistics collected are all statistics from
the RAID controller module start-of-day. Enclose the parameter in square
brackets ([ ]).
baseline This parameter defines that the statistics collected are all statistics from
the time the RAID controller modules were reset to zero using the reset
storageArray iscsiStatsBaseline command. Enclose the parameter in
square brackets ([ ]).