Dell PowerVault MD3000 - Manual (Page 189)

Script Commands
189
Syntax
set iscsiTarget unnamedDiscoverySession = (TRUE |
FALSE)
Parameter
NOTE:
Discovery is the process where initiators determine the targets that are
available. Discovery occurs at power-on/initialization and also if the bus topology
changes, for example, if an extra device is added.
NOTE:
An unnamed discovery session is a discovery session that is established
without specifying a target ID in the login request. For unnamed discovery sessions,
neither the target ID or the target portal group ID are available to the targets.
Set Virtual Disk
This command defines the properties for a virtual disk. You can use most of
the parameters to define properties for one or more virtual disks, however,
some of the parameters define properties for only one virtual disk at a time.
The syntax definitions are separated to show which parameters apply to
several virtual disks and which apply to only one virtual disk. The syntax for
virtual disk mapping is listed separately.
Syntax Applicable to One or More Virtual Disks
set (allVirtualDisks | virtualDisk
["virtualDiskName"] |
virtualDisks ["virtualDiskName1" ...
"virtualDiskNamen"] |virtualDisk <wwid>)
mediaScanEnabled=(TRUE | FALSE)
mirrorCacheEnabled=(TRUE | FALSE)
modificationPriority=(highest | high | medium |
Parameter Description
unnamedDiscoverySession This parameter turns on or turns off
unnamed discovery sessions. Set the
parameter to TRUE to turn on an
unnamed discovery sessions. Set the
parameter to FALSE to turn off an
unnamed discovery sessions.