Dell PowerVault MD3000 - Manual (Page 172)

172
Script Commands
Syntax
set host [ hostName ]
hostGroup=( “hostGroupName” | none | defaultGroup)
userLabel= “newHostName”
hostType=( hostTypeIndexLabel |
hostTypeIndexNumber )
Parameters
Parameter Description
host The name of the host that you want to assign to a host group.
Enclose the host name in square brackets ([ ]). If the host name has
special characters, you must also enclose the host name in double
quotation marks (“ ”).
hostGroup The host group to which you want to assign the host. (The following
table defines how the command runs if the host does or does not
have individual virtual disk-to-LUN mappings.) Enclose the host
group name in double quotation marks (“ ”). defaultGroup is the
host group that contains the host to which the virtual disk is mapped.
userLabel The new host name. Enclose the host name in double quotation
marks (“ ”).
hostType The index label or number of the host type for the HBA host port.
Use the
show storageArray hostTypeTable command to
generate a list of available host type identifiers. If the host type has
special characters, enclose the host type in double quotation marks
(“ ”).
Host Group Parameter Host Has Individual Virtual
Disk-to-LUN Mappings Host Does Not Have Individual
Virtual Disk-to-LUN Mappings
hostGroupName The host is removed from
the present host group and is
placed under the new host
group defined by
hostGroupName .
The host is removed from the
present host group and is
placed under the new host
group defined by
hostGroupName .