Dell PowerVault MD3000 - Manual (Page 125)

Script Commands
125
owner The RAID controller module that owns
the virtual disk. Valid RAID controller
module identifiers are 0 or 1, where 0 is
the RAID controller module on the left
and 1 is the RAID controller module on
the right when viewed from the rear of the
enclosure. If you do not specify an owner,
the RAID controller module firmware
determines the owner.
NOTE:
The owner parameter defines
which RAID controller module owns the
virtual disk. If you do not specify a capacity,
all of the available physical disk capacity in
the disk group is used. If you do not specify
capacity units, bytes are used as the
default units.
segmentSize Amount of data (in kilobytes) that the
RAID controller module writes on a single
physical disk in a virtual disk before
writing data on the next physical disk.
Valid values are 8, 16, 32, 64, 128, 256, or
512. For information about the
segmentSize parameter, see "Using the
Auto Configure Command" on page 53.
enclosureLossProtect Specifies that enclosure loss protection is
enforced when creating the disk group.
To enforce enclosure loss protection, set
this parameter to TRUE. The default
setting is FALSE. For information about
the enclosureLossProtect parameter, see
"Enclosure Loss Protection" on page 52.
Parameter Description