Dell PowerVault MD3000 - Manual (Page 188)

188
Script Commands
Set Storage Array iSNS Server Refresh
This command refreshes the network address information for the iSNS server.
This command is valid for only IPv4.
Syntax
set storageArray isnsServerRefresh
Parameters
None.
NOTE:
If the DHCP server is not operating at full capability, or if the DHCP server is
unresponsive, the refresh operation can take between two and three minutes to
complete.
NOTE:
The set storageArray isnsServerRefresh command returns
an error if you did not set the configuration method to DHCP. To set the configuration
method to DHCP, use the
set storageArray
isnsIPV4ConfigurationMethod command.
Example
-c "start storageArray isnsServerRefresh ;"
Set Storage Array Time
This command sets the clocks on both RAID controller modules in a storage
array by synchronizing the RAID controller module clocks with the clock of
the host from which you issue this command.
Syntax
set storageArray time
Parameters
None.
Set Unnamed Discovery Session
This command enables the storage array to participate in unnamed discovery
sessions.