Dell PowerVault MD3000 - Manual (Page 171)

Script Commands
171
Set Enclosure Identification
This command sets the ID of an enclosure in a storage array.
Syntax
set enclosure [" Service Tag "] id= enclosureID
Parameters
Set Host
This command assigns a host to a host group or moves a host to a different
host group. You can also create a new host group and assign the host to the
new host group with this command. The actions performed by this command
depend on whether the host has individual virtual disk-to-LUN mappings or
does not have individual virtual disk-to-LUN mappings.
assetTag Asset tag name or number to give the new enclosure. Asset tags
can be any combination of alphanumeric characters with a
maximum length of ten characters. Alphabetical characters can be
uppercase or lowercase. You can also use the underscore character
(_) and the hyphen (-) character. You cannot use spaces in an asset
tag name. You must put quotation marks (" ") around the asset tag
name.
Parameter Description
enclosure Service tag of the RAID enclosure or the
expansion enclosure for which you are setting the
enclosure ID. You must put quotation marks (" ")
around the Service Tag.
id Specifies the value for the RAID enclosure or
expansion enclosure ID. Valid values are 00
through 99. You do not need to put parentheses
around the enclosure ID value.
Parameter Description