Dell PowerVault MD3000 - Manual (Page 204)

204
Script Commands
NOTE:
When you save the information to a file, you can use the information as a
record of your configuration and as an aid during recovery.
Show Storage Array Autoconfigure
This command shows the default autoconfiguration that the storage array
creates if you issue the autoConfigure storageArray command. To determine
whether the storage array can support specific properties, enter the parameter
for the properties when you issue this command. You do not, however, need to
enter any parameters for this command to return configuration information.
If you do not specify any properties, this command returns the RAID 5
candidates for each physical disk type. If RAID 5 candidates are not available,
this command returns candidates for RAID 1 or RAID 0. When you specify
auto-configuration properties, the RAID controller modules validate that the
firmware can support the properties.
Syntax
show storageArray autoConfiguration
[physicalDiskType=(SAS | SATA)
raidLevel=(0 | 1 | 5)
diskGroupWidth= numberOfPhysicalDisks
diskGroupCount= numberOfDiskGroups
virtualDisksPerGroupCount=
numberOfVirtualDisksPerGroup hotSpareCount=
numberOfHotspares
segmentSize= segmentSizeValue ]
time Displays the current time to which both RAID controller
modules in the storage array are set.
virtualDiskDistrib
ution Displays the current RAID controller module owner for each
virtual disk in the storage array.
summary Returns a concise list of information about the storage array
configuration.
Parameter Description