Dell PowerEdge C6145 - Manual (Page 158)

158 | Installing System Components
to the system-board assembly. See Figure 3-26.
5 Reconnect all the cables to the 10GbE mezzanine card.
6 Install the system-board assembly. See "Installing a System-Board
Assembly" on page 116.
7 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
Removing the Mellanox Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from its electrical outlet.
2 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 115.
3 Disconnect all the cables from the Mellanox card.
4 Remove the three screws that secure the Mellanox card assembly. See
Figure 3-28.
5 Lift the Mellanox card assembly away from the mezzanine-card bridge
board on the system board. See Figure 3-28.