5" backplane with expander jumper settings – Dell PowerEdge C6145 User Manual
Page 244
244
|
Jumpers and Connectors
3.5"
Backplane With Expander Jumper Settings
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
Figure 5-18. Jumpers Installed on 3.5" Backplane With Expander
Table 5-3. Jumpers Installed on 3.5" Backplane With Expander
Jumper Function
Off
On
A
Project_select <1> Reserved for factory setting Reserved for factory
setting
B
Project_select <0> Reserved for factory setting Reserved for factory
setting
C
BOB_UART_SEL
*General UART Port
Selected
Serial Debug Port
Selected
D
NC_J14_PIN7
No function
NOTE: The * in the table of backplane jumper describes the default status
and the default state is not active state.