Dell PowerEdge C6145 - Manual (Page 206)

206 | Installing System Components
Figure 3-55. Removing and Installing the Sensor Board
1 sensor board 2 screw
Installing the Sensor Board for 3.5” Hard Drive System
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Replace the sensor board into the hard-drive cage. See Figure 3-55.
2 Replace the screw that secures the sensor board to the hard-drive cage.
See Figure 3-55.
3 Connect the sensor board cable to the sensor board.
4 Replace the hard-drive cage into the chassis. See Figure 3-43.
5 Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-43.
6 Connect all the cables to the backplane. See Figure 5-3 for 3.5 " hard