Dell PowerEdge C6145 - Manual (Page 211)

Installing System Components | 211
4 Connect the sensor board cable to the sensor board.
5 Replace the hard-drive cage into the chassis. See Figure 3-43.
6 Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-42.
7 Connect all the cables to the backplane. See Figure 5-7 for 2.5 " hard
drives.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
8 Connect front panel cables to the fan controller board. See Figure 3-48.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
9 Close the system. See "Closing the System" on page 174.
10 Replace the hard drives. See "Installing a Hard Drive Into a Hard-Drive
Carrier" on page 109.
11 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.