Dell PowerEdge C6145 - Manual (Page 242)

242 | Jumpers and Connectors
Switch and Jumper Settings
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
System Configuration Switch Settings
The function of system configuration switch installed on each system board
is shown below:
Figure 5-16. System Configuration Switch
Table 5-1. System Configuration Switch
Jumper Function Off On
SW 1 NVRAM Clear *Disable Enable
SW 2 System Reset *Disable Enable
SW 3 Clear Password Enable *Disable Enable
SW 4 BMC NMI Enable *Disable Enable
NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.