Dell PowerEdge R715 - Manual (Page 107)

Installing System Components 107
5 Lift the expansion-card latch and remove the filler bracket. See Figure 3-15.
NOTE: To install an expansion card in the expansion-card connector on the
system board, go to step 7.
6 Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
7 Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
8 Replace the expansion-card latch. See Figure 3-15.
Figure 3-15. Installing and Removing an Expansion Card
1 expansion-card latch 2 expansion card
3 expansion-card connector
1
2
3
book.book Page 107 Thursday, June 3, 2010 4:35 PM