Dell PowerEdge R715 - Manual (Page 139)

Installing System Components 139
Installing the Control Panel Display Module
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Insert the display module into the chassis cutout and secure the module
with the two Torx screws. See Figure 3-28.
2 Attach the replacement panel to the front of the display module.
3 Connect the display module cable to the control panel board.
See Figure 3-28.
NOTE: Ensure that you release the cable clamp before connecting the cable
and then latch the clamp after connecting the cable.
4 Close the system. See "Closing the System" on page 79.
5 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
6 If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 77.
book.book Page 139 Thursday, June 3, 2010 4:35 PM