Dell PowerEdge R715 User Manual
Page 40
40
About Your System
Alert! Node
Interleaving
disabled! Memory
configuration
does not support
Node
Interleaving.
The memory configuration
has changed (for example, a
memory module has failed)
so that node interleaving
cannot be supported. The
system will run but without
node interleaving.
Ensure that the memory
modules are installed in a
configuration that supports
node interleaving. Check
other system messages for
additional information for
possible causes. For memory
configuration information,
the problem persists, see
Alert! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Alert!
Continuing
system boot
accepts the risk
that system may
power down
without warning.
The system configuration of
processor(s), memory
modules, and expansion
cards may not be supported
by the power supplies.
If any system components
were just upgraded, return
the system to the previous
configuration. If the system
boots without this warning,
then the replaced
component(s) are not
supported with this power
supply. If Energy Smart
power supplies are installed,
replace them with the High
Output power supplies to use
the components. See "Power
Alert! Redundant
memory disabled!
Memory
configuration
does not support
redundant
memory.
Redundant memory was
enabled in the system setup
program, but the current
configuration does not
support redundant memory.
A memory module may be
faulty.
Check the memory modules
for failure. See
Memory" on page 157. Reset
the memory setting, if
appropriate. See "Using the
Message
Causes
Corrective Actions
book.book Page 40 Thursday, June 3, 2010 4:35 PM