Installing expansion-card riser 2, Integrated storage controller card, Removing the integrated storage controller card – Dell PowerEdge R715 User Manual
Page 113: Removing the integrated storage, Controller card, And "installing expansion, Integrated storage, Controller card" on, Removing the
Installing System Components
113
Installing Expansion-Card Riser 2
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Align the expansion-card riser with the riser guide pins on the system
board and the slot on the chassis. See Figure 3-16.
2 Lower the expansion-card riser into place until the expansion-card riser
connector is fully seated.
3 If applicable, replace the expansion card(s). See "Installing an Expansion
Card" on page 106 on page 72.
4 Close the system. See "Closing the System" on page 79.
5 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Integrated Storage Controller Card
Your system includes a dedicated expansion-card slot on expansion-card
riser 1 for an integrated controller card that provides the integrated storage
subsystem for your system’s internal hard drives. The controller supports SAS
SATA, and SSD hard drives and also enables you to set up the hard drives in
RAID configurations as supported by the version of the storage controller
included with your system.
Removing the Integrated Storage Controller Card
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 78.
book.book Page 113 Thursday, June 3, 2010 4:35 PM