Installing the internal dual sd module, Processors, Removing a processor – Dell PowerEdge R715 User Manual

Page 123: See "processors" on

Advertising
background image

Installing System Components

123

Installing the Internal Dual SD Module

CAUTION:

Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System" on page 78.
3 Position the module so the tabs on the underside of the tray fit into the

hooks on the front-chassis assembly, then lower the opposite edge of the

card into place. See Figure 3-1 and Figure 3-21.

4 Connect the internal dual SD module cable to the connector on the

control panel board.

5 Close the system. See "Closing the System" on page 79.
6 Reconnect the system to its electrical outlet and turn the system on,

including any attached peripherals.

Processors

Removing a Processor

CAUTION:

Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.

1 Prior to upgrading your system, download the latest system BIOS version

from support.dell.com/downloads and follow the instructions included

in the compressed download file to install the update on your system.

2 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet. When disconnected from AC power,

press and hold the power button for three seconds to fully drain the system

of stored power prior to removing the cover.

book.book Page 123 Thursday, June 3, 2010 4:35 PM

Advertising