Dell PowerEdge R715 - Manual (Page 160)

160 Troubleshooting Your System
Troubleshooting an SD Card
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Enter the System Setup program and ensure that the internal SD card port
is enabled. See "Integrated Devices Screen" on page 62.
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
3 Open the system. See "Opening the System" on page 78.
4 Reseat the SD module cable. See "Installing the Internal Dual SD Module"
on page 123.
CAUTION: If the Redundancy option is set to Mirror Mode in the Integrated
Devices screen of the system setup, you must follow the instructions in step 5 to
step 9 to avoid loss of data. If the Redundancy option is set to Disabled, proceed to
step 10.
NOTE: When an SD card failure occurs, the internal dual SD module controller
notifies the system. On the next reboot, the system prompts you with a message
indicating the failure.
5 If SD card 1 has failed, remove the card from SD card slot 1. See
"Removing the Internal Dual SD Module" on page 121. If SD card 2 has
failed, install a new SD card in SD card slot 2 and proceed to step 8.
6 Remove the card present in SD card slot 2 and insert it into SD card slot 1.
See "Removing the Internal Dual SD Module" on page 121 and "Installing
the Internal Dual SD Module" on page 123.
7 Insert the new SD card into SD card slot 2. See Figure 3-21.
8 Close the system. See "Closing the System" on page 79.
9 Turn on the system and attached peripherals and check if the SD card is
functioning.
10 Insert a different SD card that you know works properly.
book.book Page 160 Thursday, June 3, 2010 4:35 PM