Dell PowerEdge R715 - Manual (Page 121)

Installing System Components 121
VFlash Media (Optional)
The VFlash media card is a Secure Digital (SD) card that plugs into the
optional iDRAC6 Enterprise card at the back corner of the system.
Removing a VFlash Media Card
To remove the VFlash media, push inward on the card to release it, and pull
the card from the card slot.
Installing a VFlash Media Card
1 Locate the VFlash media slot at the back corner of the system. See Figure 1-3.
2 With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
3 Press inward on the card to lock it into the slot.
Internal Dual SD Module (Optional)
Removing the Internal Dual SD Module
When the Redundancy option is set to Mirror Mode in the Integrated
Devices screen of the system setup program, the information is replicated
from one SD card to another. See "Integrated Devices Screen" on page 62.
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 78.
3 If installed, remove the SD cards from the internal dual SD module.
See Figure 3-1.
4 Disconnect the cable from the internal dual SD module. See Figure 3-21.
book.book Page 121 Thursday, June 3, 2010 4:35 PM