AVer NXU8000 - Manual (Page 119)

107
(15) System Controller Setup
To configure the parameters that is for communicating with the System Controller (an optional
accessory). For operating of the System Controller, please refer to user manual of System
Controller or download the manual from web site http://surveillance.aver.com/ .

Enable
– Mark the check box to enable the System Controller function.
 Upgrade – To update the firmware of the System Controller (see also Upgrading the Firmware of
the System Controller ).

Model
– Select model of the System Controller. If System Controller is connecting to DVR
through the USB port, please select the System Controller Pro mode. If System Controller is
connecting to DVR through the RS485 port, please select the System Controller Pro 485 model.

Port
– Select the com port that is connected with the System Controller Pro.
i
Only when System Controller is using RS485 port connect to DVR server, the port needs to
be selected.
 ID – Set an ID for DVR server (0~99). This ID is a key for the System Controller to control the
DVR server when there are more than one DVR servers are connecting with the System
Controller through the RS485 port(see also Switch Control on Multiple DVR Servers ).