AVer NXU8000 - Manual (Page 270)

258
Chapter 10 Using the Remote Control Server
The bundled Remote Control Server enables the PC with Central Management System program
(CM3000) installed in it remotely access the DVR server. You may need to manually run this program
for CMS access the DVR server. To run, click Start > Programs > DVR > Remote Control Server.
The remote control server icon appears on the taskbar when the remote control server is enabled.
To change the port setting or stop server, right-click icon and then make a selection.
i
User can also setup Remote Control Server in DVR Network setting, please see Chapter 5.4
#(5) .