AVer NXU8000 - Manual (Page 92)

80
camera.
10. OSD:
To allow call out PTZ camera factory’s OSD setup menu if the PTZ camera has supported.
The OSD setup menu may vary that depends on the brand of PTZ camera.
11. When is done, click OK to save the setting or Click Cancel, to leave without saving the new
setting.
12. When PTZ camera is enabling, user can control PTZ camera by using PTZ control panel.
13. Click the channel that has supported and enabled the PTZ function. And then, click PTZ button
on preview UI. The PTZ control panel will show up on the screen.
i
- User can move the on screen PTZ controller to any position of screen
- The on screen PTZ controller only display on a channel screen at a time.