AVer NXU8000 - Manual (Page 177)

165
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such as
motion detected and video loss, the alarm will reset at the alarm reset time.
7. In (6) Priority, user can set the priority of this alarm. The priority of the alarm can be seen in CMS
site (Central Management System).
8. In (7) Action, you may now set the alarm action for the system to perform when the alarm
condition is activated.
- Launch Emap
Display mini Emap screen.
- TV Out
i
Alarm T V Out doesn’t support on NVR server.
Switch to only display the video on TV from where the alarm is activated or selected camera.
a. Select the camera from drop down list to specify which camera video to be displayed on
TV when the alarm is triggered.
 Alarm Camera: when a channel has an alarm occurred, and then, the channel video
that has an alarm occurred will be displayed on TV.
 Camera #(1~32): select the camera channel video that wants to be displayed on TV
when an alarm is activated.
b. Retrieve time: set the waiting duration before system switching back to original display
mode on TV automatically. If the retrieve time is un-mark, the alarm video will keep
displaying until user switch back to normal display mode manually. The retrieve time range
is 3~ 600 seconds.
- Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on
screen when the alarm is triggered.

Alarm Camera: when a channel has an alarm occurred, and then, the channel video
that has an alarm occurred will be enlarged on screen.
 Camera # (1~32): the selected channel video that will be enlarged on screen when
an alarm is activated.