AVer NXU8000 - Manual (Page 189)

177
5.9.12 Missing, Suspicious Object, and Scene Change Detected
 Missing Object
Select the certain object on the screen for the system to detect; when the object is disappear or
move and the system will alarm. Click OK to exit and save the configuration. To exam the setup
condition, click Start Test.
1. Select the camera number (0-16) and press RIGHT button on the mouse to call up the setup
window.
2. Click Save to capture the image for comparing reference first. To view the captured image,
enable the Show Reference Image check box. The captured image will display on screen.
The reference image is sharing with the Suspicious Object and Scene Change function.
3. Mark the Enable check box to setup the condition.
4. Use the mouse to click and drag the frame on the screen. User can drag more than one
frame.
5. Sensitivity: Set the system detects sensitivity.
6. Delay Time: Set the lasting time for system to detect the object.
7. To reset all object frames, click Clean. To clean an object frame, click right button of mouse
and drag the object frame that user want to clean.
 Suspicious Object
Suspicious Object is including the object missing or the doubtful object appears on the screen.
Click OK to save and exit the setup window. To exam the setup condition, click Start Test.
1. Select the camera number and press right button on the mouse to call up the setup window.
And then, click the Suspicious Object Tab.
2. Click Save to capture the image for comparing reference. To view the captured image,
enable the Show Reference Image check box. The captured image will display on screen.
The reference image is sharing with the Missing Object and Scene Change function.
3. Mark the Enable check box to setup the condition.
4. Sensitive: Set the system detects sensitivity.
5. Delay Time: Set the lasting time for system to detect the object.
6. Use the mouse to click and drag the frame on the screen.
 Maximum_Object: the maximum detect size. The objects are out of the maximum
detect area will be disregard. Use mouse to click and drag the frame on the screen.
 Minimum_Object: the minimum detect area. When the objects are smaller than the
minimum detect area, the system will disregard. Use mouse to click and drag the frame
on the screen.
7. Enable Mask
Mark an area on the screen to disregards the motion in the marked area and to only monitor
outside the marked area. Mark the Enable Mask check box, click and drag the mask frame
on the screen.