AVer NXU8000 - Manual (Page 138)

126
(6) Input
 Add IPCam: To connect an IP camera or Remote DVR. Click Add IPCam button and select the
type of camera and click OK to continue.
- Add IP Camera: In the Add IPCam window, select to connect using Protocol or URL and
then enter the required info. If the IP camera IP address is available, enter the IP address at IP
Camera Site column. If IP camera requires user identification, enable Authentication check
box and enter ID and Password. To enable audio, click Enable Audio check box. If you are
not sure of the Protocol or URL info, please refer to the IP camera manual or contact your IP
camera local distributor. Click Save & Exit to save the setting and leave the setup window, but
no connection with IP camera. To connect IP camera, click Connect button.
 Auto Search: User can click Auto Search to find the IP camera that can be detected by
NVR system on the LAN network. IP Camera Information section displays the selected
camera ’s firmware version.
i Auto Search function will find all IP camera that can be detected by NVR system on you
LAN network, but only AVer IP camera series allow to be connected to NVR system.