AVer NXU8000 - Manual (Page 178)

166
b. Select the display mode
– 1 Channel or Full Screen.
c. Retrieve time: set the waiting duration before system switching back to original Preview
mode. If the retrieve time is un-mark, the alarm video will keep enlarging until user switch
back to Preview mode manually. The retrieve time range is 3~ 600 seconds.
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend additional
time in second before it stops the relay operation.
- IP Camera Relay
Set to enable/disable the relay operation when the alarm is activated.
- Play Warning Sound
Play alarm sound. To setup click Detail (see also
Chapter 5.9.2 ).
- Make Phone Calls
Dial and contact the number in the list. To setup click Detail (see also
Chapter 5.9.3 ). To use
this feature, the PC must have a voice modem connected to it. The supported audio system is
only 8KHz and 16Bit mono.
- Send E-mail
Send an electronic text message. To setup click Detail (see also
Chapter 5.9.4 ).
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail (see
also
Chapter 5.9.5 ).
- Start Recording
Record the video from the selected camera. To setup click Detail (see also
Chapter 5.9.6 ).
- SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages and
images over wireless networks using the wireless application protocol (WAP). Make sure your
mobile phone support this feature and your PC is connected to GSM/GPRS modem. To setup
click Detail (see also
Chapter 5.9.7 ).