AVer NXU8000 - Manual (Page 141)

129
- Transcode by MPEG4 Encoder: NVR system is decoding the video and compress
video again by using MPEG4 encoder.
 Preview Setting: preview setting will relate to the Save Original Format.
- Decode key frame for Preview: When previewing video, NVR system only shows key
frame and one frame per second.
- Enable live display performance optimization: The live video performance will be
optimized while display.
- Enable update when motion: The video will update only when compare the key frame
has motion found, and then, the video will be displayed.
 Schedule Connect
User can select a certain date and time to connect with IP camera. The blue block means
connect with IP camera and the white block means disconnect with IP camera. Select the
connection status (blue or white) and click the date and time block to set the connection
schedule.
 I/O Control: To setup the sensor and relay devices that is installed on IP camera.
 Sensor Setting: To setup sensor that is
embedded on the camera.
1. Click the drop-down list and select the
sensor ID number.
2. Enter sensor name in Name column
3. The system automatically detects the
camera and input relates information. In
the
Content section, enter sensor
description.
4. In the test section, click Test to check the
sensor status. Red is high and Green is
low.
5. Click OK to exit and accept the setting and
Cancel to exit without saving the setting.