AVer NXU8000 - Manual (Page 165)

153
- Enable Network
Activate DVR remote system to access at the set time. After the appointed time, the Network
function will be disabled. If the Network function is already enabled, the Network function will
not be disabled when the appointed time has ended.
- Reboot
Restart the PC at the appointed time.
i Make sure the Windows operating system is set NOT to require you to login user name
and password. This way the system will be able to run DVR program.
- Disable Alarm
Deactivate the alarm at the set time temporarily.
- Turn on Relay #
Active the Relay at the set time. If there are no Relays are connected, Turn on Relay #
function will not display in drag down list. The Relay number will depend on how many Relays
are connected.
3. Specify to either schedule it weekly or one time. Click  to make a selection.
4. Click on the blocks to set the schedule (see also
Chapter 5.5.1 ). Or click All to select all. To store
the setting, click Save. To remove the settings, click Clear.
5. To end Schedule Setting, click OK to exit and accept the setting and Cancel to exit without saving
the setting.
5.5.1 To set schedule at a specific portion of time in that hour
1. Right click the colored blocks.
2. In the Select time dialog box, click to enable or disable the portion you want to set.
3. Click OK to accept the setting and Cancel to exit without saving the setting.