AVer NXU8000 - Manual (Page 134)

122
 Detail setting of IP camera: In Camera Setting interface, click Detail to configure more
parameters of the IP camera. Click OK to save the configuration and exit the setup
window. To reset the configuration back to factory value, click Default.
User can select Video size, Frame rate, Video and Quality Mode of camera. And scroll
the bar to adjust the Quality, Brightness, Contrast, Hue, Saturation, and Sharpness of
the camera.
 Recording Setting
- Save Original Format: Save the video that is compressed by IP camera’s
compress mode.
- Transcode by MPEG4 Encoder: DVR system is decoding the video and compress
video again by using MPEG4 encoder.
 Preview Setting: preview setting will relate to the Save Original Format.
- Decode key frame for Preview: When previewing video, DVR system only shows
key frame and one frame per second.
- Enable live display performance optimization: The live video performance will be
optimized while display.
- Enable update when motion: The video will update only when compare the key
frame has motion found, and then, the video will be displayed.
 Schedule Connect
User can select a certain date
and time to connect with IP
camera. The blue block means
connect with IP camera and
the white block means
disconnect with IP camera.
Select the connection status
(blue or white) and click the