AVer NXU8000 - Manual (Page 179)

167
- PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see also
Chapter 5.9.8 ).
- Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To setup
click Detail (see also
Chapter 5.9.9 ).
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated (see
also
Chapter 5.9.10 )
- Launch Program
To call up the external program that is provided by 3 rd party. Click Detail and click to
locate the program path. Enable Multiple instance check box to allow the program can be
executed multiple times at the same time.
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video to be snapshot when the alarm is occurred.
- Alarm Camera: when a channel has an alarm occurred, and then, the DVR system
will snapshot the channel video.
- Camera # (1~32): the selected channel would be snapshot when an alarm is occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.
d. Snapshot Interval: a time gap for next snapshot
e. Save Path: a storage path for saving snapshot pictures.
f. Delete image after: set a storage limit of snapshot image. When the snapshot image is
over the limit, and then, the system will start recycle the snapshot image.