FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 149)

was no response received. Error type: RETRYABLE.
1131 No more baud rates to try: After a 4th ppr signal is received, a CTC signal is sent so as to step
down the baud to the next configured baud rate. All configured baud rates have been exhausted. Error
type: RETRYABLE.
1132 No response to CTC: No response after CTC. Error type: RETRYABLE
.
1133 Invalid response to CTC: The expected signal after CTC is CTR. Some other signal was
received. Error type: RETRYABLE.
1134 Invalid response after ECM block: After receiving an ECM block, the expected signals are PPS,
CTC or RR. Some other signal was received. Error type: NON_RETRYABLE.
1135 Unexpected DCN: During receive, a DCN signal was received at a point where it is not expected.
This most commonly occurs under ECM. For non­ECM faxes, a DCN received after page data does not
generate an error since some fax machines don’t bother with a post page signal on the last page. Error
type: NON_RETRYABLE.
1136 Call hung up before fax was complete: The modem returned a NO CARRIER while sending.
Error type: RETRYABLE.
1137 The sender specified a modulation that is not supported: The DCS has an invalid baud
rate/modulation specified. Error type: NON_RETRYABLE.
1138 ECM required for V.34: The remote does not support error correction mode which is required
for the V.34 connection that was established. Error type: NON_RETRYABLE.
1139 Unexpected V.34 end­of­transmission: Remote fax sent an unexpected V.34 modulation end
of transmission indication. Error type: RETRYABLE.
1140 V.34 did not step down baud after fourth PPR: We received the 4th PPR when sending a fax
using V.34 modulation and the receiver did not step down the baud rate. Error type: NON_RETRYABLE.
4.1.3 1281–1626: Class 2 Driver
1281 No Answer: Ring detect without successful handshake. Error type: RETRYABLE.
1282 Call aborted from +FK or <CAN>. Error type: NON_RETRYABLE.
1283 No dial tone: By default, the modem will listen for dial tone before trying to place an outbound
call. The most common cause of this error is not having a working phone line plugged into this port. If
the phone lines do not provide dial tone, the modem must be configured to not detect dial tone before
dialing (see dial_progress_mode). Error type: NO_DIAL_TONE.
1290 Unspecified Phase A error. Error type: RETRYABLE.
1291 Timed out waiting for a command: During phase B, the T1 timer expired while waiting for
commands from the sending fax machine. This timer is35 seconds. Error type: RETRYABLE.
1300 Unspecified transmit phase B error. Error type: RETRYABLE.
1301 Remote fax cannot receive: The remote fax device is configured to not receive faxes. Error
type: NON_RETRYABLE.
1302 Command received error in transmit phase B. Error type: RETRYABLE.
1303 Invalid command received in transmit phase B. Error type: RETRYABLE.
1304 Response received error in transmit phase B. Error type: RETRYABLE.
1305 DCS sent three times without response. Error type: RETRYABLE.
1306 DIS/DTC sent 3 times: DCS not recognized. Error type: RETRYABLE.
1307 Failure to train at 2400 bps or +FMINSP value. Error type: RETRYABLE.
1308 Invalid response received in transmit phase B. Error type: RETRYABLE.
Proprietary FaxBack, Inc. 2014 149