FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 187)

show_ring0_buffer_size [dword 0–4294967295]: How big of buffer for the page locked
debug buffer that ring0 code writes to and ring3 code extracts from (on a thread) to the
debugging output. This should be larger for when using serial capture mode since so much more
data is written for debug. It should probably be only about 1K for when using T.30 debug since
the frequency and amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default: 65536.
sip_from_domain [string]: Overrides the domain part of the From header.
sip_port_number [dword 1–65535]: Specifies the port number that the IP fax driver will use
to listen for SIP packets that are delivered over UDP. If the specified port number is used by
another application on the same computer (using UDP), then the IP fax driver will not load.
Default: 5060.
sip_max_forwards [dword 0–256]: Specifies the value that the IP fax driver will set for the
Max­Forwards: field in SIP messages that it sends. Default: 70.
sip_sdp_username [string]: The name to use in the o= owner attribute in the SDP. Default:
IPFax.
sip_proxy [string]: The IP address or host name to use as a SIP proxy.
sip_proxy_password [string]: If the SIP proxy challenges for authentication, use this
password.
sip_proxy_user_name [string]: If the SIP proxy challenges for authentication, use this user
name.
sip_registrar [string]: The IP address or host name to REGISTER with (the “registrar”).
sip_registrar_aor [string]: The AoR to use for the REGISTER message. Typically set to the
same as the user name.
sip_registrar_password [string]: The password to use for the REGISTER message.
sip_registrar_refresh_seconds [dword 0–65535]: When registration is enabled, refresh the
registration after this many seconds. If set to zero, the refresh is sent after 80% of the
registrar’s “expires” response. If the registrar does not specify an “expires”, then the
registration is refreshed every 60 seconds.
sip_registrar_user_name [string]: The user name to use for the REGISTER message.
sip_remote_ip_address [string]: Specifies the IP address, and optionally port number, of the
T38 router/gateway that the IP fax driver will use when sending faxes. The router/gateway
must support SIP 2.0 over UDP. If an IP address is provided without a port number, for
example, 10.0.0.15, then the IP fax driver will use a port number of 5060. To provide an
alternate port number, append a colon (:) then port number to the IP address, for example,
10.0.0.15:5061.
sip_mode [string]: This governs alternate behaviors for IP_FAX initial INVITE.
Format: Comma separated list of the following:
T38_INVITE – Outbound initial INVITE will specify both G.711 μ­law / T.38 in its SDP.
Proprietary FaxBack, Inc. 2014 187