FaxBack NET SatisFAXtion 9.0 - Fax Server Manual - Manual (Page 186)

RTP Log each sent or received audio packet.
CALL_PROGRESS Log periodic audio state during the RTP portion of the call (pre­T.38
reinvite).
debug_show_tcp_url [string]: Connect to this host:port to log debug information.
debug_show_output [string]: Debug output that displays various run time behavior of
ICANFax. When specifying the FAX_DEVICE, the ICANFax debug output will be mixed in with
the fax drivers debug output. This is a device specific setting, but you can set the default for all
devices by specifying this under the global section. Format: One of the following values.
Default: NONE.
NONE
CONSOLE
FILE
FAX_DEVICE
SERIAL_CAPTURE
TCP
dial_prefix [string(20)]: Data to be prepended to dial strings, typically 9, if present.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state before hanging up.
Default: 45.
end_port_number [dword 1–65535]: Last UDP port to allocate for RTP and T.38. Default:
49151.
firewall_name [string]: The base name for any Windows Firewall exceptions created by the
IP_FAX driver. Default: IP_FAX.
io_buffer_size [dword 0–65535]: This is the size of the image buffer. The necessary buffer
size depends on host CPU speed and load as well as connect speed. This buffer directly adds to
driver page locked memory use so should be as small as possible. However, too small a buffer
will cause faxes to fail. Default: 20480.
local_ip_address [string]: Public IP address of NAT, for use with STUN. Specifically, this will
override the domain part of the Contact: header. Only an IP address is valid here, not a name.
phone_number [string]: Specifies a value that the IP fax driver sets in the From: header of
SIP messages that it creates, identifying the IP fax port. A VoIP router can, if so configured, pass
along this value as the caller ID (ANI) for the outbound fax call.
post_page_holdup [boolean]: For non­ECM fax receive, this causes the driver to wait until the
app reading image data acknowledges quality of the page. This allows the driver to respond with
MCF, RTP or RTN. Disabling this will allow for the drivers receive page buffering for latent apps.
See also ICANFAX\rtp_percent, ICANFAX\rtn_percent. Default: true.
rings_before_answer [dword 0–255]: Number of rings before modem accepts call.
Default: 1.
sdp_session_name [string]: Name to use for the s= session name attribute in the SDP.
Default: SIP Fax Call.
show_console_scroll_back_buffer_size [dword 0–4294967295]: When the debug output
is CONSOLE, this is how big of a buffer to be used for scrollback. Default: 282144.
Proprietary FaxBack, Inc. 2014 186