KEYENCE LS-7000 - Manual (Page 103)

4-51
Chapter 4 Function Settings
4
Limit Settings
Take the following steps to make tolerance settings in reference value mode or threshold
mode.
Refer to Selection of Measured Value Display on page 3-2 to change OUT1 to OUT2 or
vice versa.
■ Reference Value Mode
1
Press the key corresponding to the
type of tolerance to be set.
Press the
HI
key to set the upper limit,
the GO key to set the reference value,
and the
LO
key to set the lower limit.
The corresponding tolerance item
flashes.
HI
GO
LO
2
Press the or key and set the
tolerance.
3
Press the flashing tolerance key
again.
The input item is entered.
PROG No.
PRINT
AREA DISP
ESC G
C ENT
HOLD
ZERO
FOCUS
A POSITION
HI
GO
LO
Press these keys to set the value.
■ Threshold Mode
The following values displayed can be set in threshold mode.
HI
HI
LO
LO
HI set value
HH set value
LO set value
LL set value
Press the key.
Press the key twice.
Press the key.
Press the key twice.