KEYENCE LS-5000 - Manual (Page 117)

Chapter 10 Display System Setup
111
10
10.3 Replacing Protective Sheet
To replace the protective sheet, perform the following procedure.
■ LS-5501
1. Remove the old protective sheet.
2. Peel the edge of the release film from the back of a new protective sheet, and
align the corners of the protective sheet with the corners of the touch panel.
3. While slowly removing the release film, apply the protective sheet to the touch
panel so that there is no air between the sheet and the panel.
Protective sheet (for protection against flaws and reflection)
5 sheets/set: OP-23976
Align the corners of
the protective sheet
with the corners of
the touch panel.