KEYENCE LS-5000 - Manual (Page 89)

Chapter 7 Pitch Mode
83
7
● Self-timing hold mode
Measurement can be automatically performed according to the internal synchro-
nous signal.
Timing Diagram
• When the self-timing period has passed after a target is placed in the measuring
area, the measured value is retained.
• The previous value is retained until the self-timing period has passed after the
next target is placed in the measuring area.
• If the number of pitches of an actual target is different from the preset number of
pitches, self-timing mode is not activated even when the target is placed in the
measuring area.
OK
ON
OFF
NG
ON
OFF
OFF
Err
ON
No target
Target enters the
measuring area
No target
Preset
self-timing
interval
Preset
self-timing
interval
Upper limit
Max. value
Min. value
Lower limit
Target enters the
measuring area Target goes out of
the measuring
area