1 quick start reference, 1 procedure for starting measurement – KEYENCE LS-5000 User Manual

Page 22

Advertising
background image

Chapter 3 Quick Start Reference

16

3

3.1

Quick Start Reference

This section describes the procedures for starting measurement for trial operation.

3.1.1 Procedure for Starting Measurement

Before changing the measuring mode or the number of averaging measurements,
read this instruction manual thoroughly for the correct settings.
For setting items, see the table of contents.

The following is reference page numbers for typical operations.

• Changing the DIA mode to EDGE mode ............................................... p.39, 40

• Changing the number of averaging measurements ............................... p.44, 45

• Changing the measuring mode ........................................................... p.46 to 51

• Simultaneous measurement ........................................................................ p.32

• (X + Y)/2 measurement using two scanning heads ............................... p.41, 42

Connect the controller and scanning head.

Turn the power on.

Align the optical axis of the transmitter and
receiver.

The 5001 series starts laser emission in
approximately 5 seconds, at which time the
measurement begins.

Place a target in the measuring area.

The measured value is soon displayed.

For information on the connection
procedure, see p. 8.

• When the transmitter and receiver are

fixed to the scanning head mounting
frame, optical axis alignment is not
necessary.

• For information on the scanning head

mounting allowance, see p. 18.

For information on checking the optical
axis, see p. 60 and 61.

For information on the measuring area,
see p. 115.

The factory setting for the number of
averaging measurements is 768 for DIA
mode.

Advertising