KEYENCE LS-5000 - Manual (Page 39)

Chapter 6 Normal Mode
33
6
3. Set the output to be displayed. ( ➮ For setting outputs, see p.41.)
Turn ON the output to be displayed.
If an output is not to be displayed, press the [ON] button once to turn it OFF.
4. Return to the DISPLAY DATA screen.
Press the [DISPLAY DATA] button to return to the DISPLAY DATA screen.
■ Setting Procedure <DISPLAY GRAPH>
1. Perform steps 1 and 2 described on the previous page to go to the SCREEN
SELECT screen shown below.
2. Select “DISPLAY GRAPH”.
Select the output to be graphically displayed.
OUT1 to OUT4 are switched in the above order.
Press the [DISPLAY GRAPH] button.
3. Perform “GRAPH SETUP”.
Press the [SETUP] button.
OUT1 OUT2 OUT3 OUT4
LASER ON SCREEN NOR
MAL P. 1
DISPLAY DATA DISPLAY GRAPH
ON OUT1
SET SET
OFF OUT2
OUT1
OFF OUT3
OFF OUT4
LASER ON DISPLAY GRAPH OUT1 NOR
MAL
P. 1
SETUP SCREEN
40.0000
0.0000
DATA: 25.77110
LASER ON SCREEN NOR
MAL
P. 1
DISPLAY DATA DISPLAY GRAPH
ON OUT1
SET SET
OFF OUT2
OUT1
OFF OUT3
OFF OUT4